VW Oxygen Sensor Bosch 16132 Oxygen Sensor
- Integrated platinum electrodes produce a precise voltage signal for the engine ECU
- Advanced ceramic technology for consistent performance and long life
- Great product it has been going strong for the last 6 months. it fit my
2002 Audi a4 you just had to switch out the plug. It came with the make
and female.
VW Oxygen Sensor Bosch 16132 Oxygen Sensor
Bosch 15726 Oxygen Sensor, Universal Type Fitment
Bosch 15726 Oxygen Sensor, Universal Type Fitment
Universal sensors-Follow instructions exactly.
I
replaced a Nissan oxygen sensor previously with a Bosch unit, but it
was the kind with the connector built in. In that case there was only a
dollar or two difference in price between the universal connector (no
plug) and the one with the plug. For my other oxygen sensor (this one)
the one with the plug was almost twice the price. Hence I thought most
of the effort goes into removing the sensor, not into hooking it up, and
so I was willing to do my own splicing. Well not quite. You best follow
the instructions sequence exactly or you may get in trouble. Here are a
couple of big tips you need.
1. The cable sheath should be cut
back an extra inch shorter than instructions recommend, otherwise you
will not be able to stick the wires through the waterproof connector far
enough.
2. When cutting the original and the replacement wires leave an extra inch on each wire.
3.
Make SURE to slip the UN-stripped wire through the rubber grommets
first. I figured it would be easier to strip the wire before I threaded
all the connector stuff on it. Big mistake. The stripped wire frays so
much, and is so stiff that you cannot twist it back into a point. Once
stripped I could not get it through the rubber grommets and had to cut
off the stripped part. Hence give yourself an extra inch.
While
the sensor with the connector also came with a couple of clips to attach
the wire to body frame, the universal sensor did not. Another reason to
give yourself an extra inch or so, to route the new wire securely
without a use of a clip. You will probably destroy the old clips while
removing the old sensor. I used the PB nut buster spray on a warm
manifold and the old sensor came right out (auto parts store loaner
special slotted socket).Read more
Bosch 15726 Oxygen Sensor, Universal Type Fitment
Oxygen Sensor and Bosch 13461 Oxygen Sensor, OE Type Fitment
Oxygen Sensor and Bosch 13461 Oxygen Sensor, OE Type Fitment
After replacing the front oxygen sensor on my 2002 Hyundai Elantra GT
with a dealer purchased sensor(about 90 dollars) my check engine light
was still on. Upon further investigation with my OBD reader I realized
that it was the oxygen sensor near the catalytic converter that was bad.
When doing a search on Amazon I was surprised to find that not only
was the sensor available, it was at least half the dealer price. The
sensor was an exact match to the original and solved my check engine
light issue.
Go to Store
Oxygen Sensor and Bosch 13461 Oxygen Sensor, OE Type Fitment
